Undo a Code Replication Process

When you undo a code replication, the target instance reverts to the previously active code version. You can only run an undo process after a code replication process of type Activation or Transfer & Activation.

1. Select Administration > Replication > Code Replication. A list of existing code replication processes is displayed.
2. To undo a replication process without entering a description or configuring an email notification, click Undo next to that process. If you want to add a description or send an email notification, continue following these steps.
   You can only undo the most recent Code Activation or Code Transfer & Activation process for the target instance.
3. The system generates a process ID. You can enter a different ID.
4. From the dropdown list, select a target instance.
5. (Optional) Enter a description.
6. From the Activation Type dropdown list, select Manual.
7. From the dropdown list, select a notification email trigger. You can enter multiple target email addresses separated by commas.

   Option	Description
   -None-	No emails are sent.
   When Process Ends	Sends an email to the specified addresses when the process ends, whether it succeeds or fails. If it hangs, then no email is sent.
   When Process Fails	Sends an email to the specified addresses when the process fails. If the process succeeds or hangs, then no email is sent.
   Periodically	Enter a time period in minutes. While the process is running, emails are sent to the specified addresses at that interval until the process finishes. An email is also sent when the process succeeds or fails.

   The email notifications contain the start and end time of the process, the target system, the replication type, and the included replication tasks. If there was a failure, an error code is also included. Each process in a recurring series sends its own notification.
8. Click Next.
9. From the dropdown list, select the Undo replication type.
10. Click Next and review the process details.
11. Click Create.
12. Find the process in the list and click Start.